Heat near the brake hose comes from three directions at once: the engine block it routes past, the exhaust side it sometimes runs close to, and the braking energy the caliper dumps into the fluid on long descents.
The JUNZE hydraulic brake hose carries a +120°C upper rating — the figure published in our catalog and tested under SAE J1401, not an estimate. The low end reaches -48°C, so the same roll serves winter markets without a second specification.
For distributors in hot regions or stocking for turbocharged and compact-engine vehicles, that ceiling is the number to check first.Product Details
| Dimension. mm | Inch | I.D. mm | O.D. mm | Wall Thickness mm | Wall Diff Max.mm | Max Expansion ml/m 6.9MPa 10.3MPa | Burst Pressure Min.MPa | |
| 3.2 | 1/8" | 3.35±0.15 | 10.5±0.2 | 3.65 | 0.3 | 0.25 | 0.36 | 80 |
| 3.2 | 1/8" | 3.35±0.15 | 10.5±0.2 | 3.65 | 0.3 | 0.36 | 0.48 | 80 |
| 3.2 | 1/8" | 3.35±0.15 | 10.5±0.2 | 3.65 | 0.3 | 0.45 | 0.55 | 80 |
| 3.2 | 1/8" | 3.35±0.15 | 10.5±0.2 | 3.65 | 0.3 | 0.60 | 0.8 | 70 |
| 3.2 | 1/8" | 3.35±0.15 | 9.0±0.2 | 2.92 | 0.3 | 0.45 | 0.55 | 80 |
| 4.8 | 3/16" | 4.8±0.2 | 12.5±0.3 | 3.85 | 0.3 | 1.81 | 2.36 | 60 |
| 6.3 | 1/4" | 6.1±0.2 | 15±0.4 | 3.65 | 0.3 | 2.69 | 3.84 | 50 |
Product Information
The rating holds across the full bore range — 3.2mm, 4.8mm, and 6.3mm — with burst minimums of 80, 60, and 50 MPa respectively. The construction behind it is the standard JUNZE hydraulic hose: rubber tube, multi-strand fiber braid, weathering-resistant cover.
A note on what the rating means in practice: it covers the fluid and ambient temperature the hose sees in service. Routing that clamps the hose against a hot surface will age any hose faster than the rating implies, whatever the brand — which is why we supply the rating alongside routing guidance for large orders.
Available as bulk coils in all three bores. Ask for the spec sheet with the temperature test basis when you request pricing.
FAQ